Intake Manifold Removal and Installation
Exploded View
1. Intake Manifold - Exploded View

Removal
NOTE: Refer to the Exploded View if needed during this procedure.
1. Injector Control Module - Remove
2. Air Cleaner - Remove
3. Intake Air Duct - Remove
4. EVAP Canister Purge Hose and Connector (EVAP Canister Purge Valve) - Disconnect
5. Throttle Body - Move
NOTE: Do not disconnect the water bypass hoses.
6. Brake Booster Vacuum Hose and PCV Hose - Disconnect

- Disconnect the brake booster vacuum hose (A) and the PCV hose (B).
- Remove the hose clamps (C).
7. EGR Pipe B - Remove
8. Intake Manifold - Remove

- Remove the intake manifold mounting bolts and nuts sequentially in three steps.
- Remove the intake manifold.
9. Intake Manifold Base - Remove

- Remove the intake manifold base mounting bolts and nuts sequentially in three steps.
- Remove the intake manifold base.
Installation
NOTE: Refer to the Exploded View if needed during this procedure.
1. Intake Manifold Base - Install

- Install the intake manifold base. Tighten the bolts/nuts in three steps; tighten the bolts/nuts until the bolts/nuts sit on the intake manifold base, tighten the bolts/nuts until the gasket is compressed, tighten the bolts/nuts to specified torque.
NOTE: Always use new gaskets.
2. Intake Manifold - Install

- Install the intake manifold. Tighten the bolts/nuts in three steps; tighten the bolts/nuts until the bolts/nuts sit on the intake manifold, tighten the bolts/nuts until the gasket is compressed, tighten the bolts/nuts to specified torque.
NOTE: Always use new gaskets.
3. EGR Pipe B - Install
4. Brake Booster Vacuum Hose and PCV Hose - Connect

- Connect the brake booster vacuum hose (A) and the PCV hose (B).
- Install the hose clamps (C).
5. Throttle Body and Intake Air Duct - Install
NOTE: Always use a new throttle body gasket.
6. EVAP Canister Purge Hose and Connector (EVAP Canister Purge Valve) - Connect
7. Air Cleaner - Install
8. Injector Control Module - Install