Input Shaft (Mainshaft) Speed Sensor Removal and Installation
In this manual: Input Shaft (Mainshaft) Speed Sensor Removal and Installation
2steps
~12min
1/5difficulty
Done 0 of 2
Removal/Installation
1. Front Bulkhead Cover - Remove
2. Air Intake Tube - Remove

3. Air Cleaner - Remove
4. 12 Volt Battery - Remove
5. 12 Volt Battery Box - Remove

- Disconnect the connector (A).
6. 12 Volt Battery Duct - Remove
7. Battery Base - Remove

- Remove the harness clamps (A).
8. Input Shaft (Mainshaft) Speed Sensor - Remove

- Disconnect the connector (A).
- Remove the input shaft (mainshaft) speed sensor (B) with the O-ring (C).
9. All Removed Parts - Install
- Install the parts in the reverse order of removal.
Was this page helpful?