Front Passenger's Weight Sensor Output Check After a Vehicle Collision
In this manual: Front Passenger's Weight Sensor Output Check After a Vehicle Collision
3steps
~18min
2/5difficulty
Done 0 of 3
Procedure
NOTE: Check the front passenger's weight sensor output after a vehicle collision.
1. HDS - Connect
2. Front Passenger's Weight Sensor - Output Check After a Vehicle Collision
Front Passenger's Weight Sensor Output Check After a Vehicle Collision
- Make sure all the components of the front passenger's seat are correctly installed.
- Position the front passenger's seat all the way rearward, and adjust the seat-back to the forward most position. Do not move the seat from this position until the output check is completed.
- Make sure nothing is on the front passenger's seat, including aftermarket seat covers or mats.
- Make sure nothing is in the front passenger's seat-back pocket.
- Keep the windows and the moonroof closed (if equipped).
- Make sure the vehicle is on level ground.
- Dehumidify inside of the vehicle with A/C.
- Do not touch the front passenger's seat during the output check.
- Do not expose the front passenger's seat to sudden temperature changes.
- Make sure all aftermarket devices (amplifiers, fluorescent light, air purifiers, CB or HAM radios, etc.) are turned off.
- Drive the vehicle, accelerate to 36 km/h, then stop on level ground.
- From SRS in the HDS Main Menu, select SWS, then Inspection. In the Inspection Menu, select AFTER A VEHICLE COLLISION. Follow the prompts until the front passenger's weight sensor output check has been completed.
- Turn the vehicle to the OFF (LOCK) mode.
Was this page helpful?