Valve, Spring, and Valve Seal Removal and Installation
In this manual: Valve, Spring, and Valve Seal Removal and Installation
12steps
~72min
3/5difficulty
Done 0 of 12
Removal
NOTE: Identify the valves and the valve springs as they are removed so that each item can be reinstalled in its original position.
1. Cylinder Head - Remove
2. Camshaft - Remove
3. Valve and Valve Spring - Remove

- Using an appropriate-sized socket (A) and a plastic mallet, lightly tap the spring retainer to loosen the valve cotters.

- Install the valve spring compressor attachment and the valve spring compressor. Compress the spring and remove the valve cotters.
- Remove the valve spring compressor and the valve spring compressor attachment, then remove the spring retainer, the valve spring, and the valve.
4. Valve Seal - Remove

- Install a valve guide seal remover (A).

- Remove the valve seals.
5. Valve Spring Seat - Remove

Installation
1. Valve Spring Seat - Install

2. Valve and Valve Seal - Install

- Coat the valve stems with new engine oil. Install the valves in the valve guides.
- Check that the valves move up and down smoothly.
- Install new valve seals (A) using the 5.5 mm side of the stem seal driver.
NOTE: Exhaust valve seals (B) have a black spring (C) and intake valve seals (D) have a white or silver spring (E); they are not interchangeable.
3. Valve Spring - Install

- Install the valve spring and the spring retainer. Place the end of the valve spring with closely wound coils toward the cylinder head.
- Install the valve spring compressor attachment and the valve spring compressor. Compress the spring and install the valve cotters.
- Remove the valve spring compressor and the valve spring compressor attachment.

- Lightly tap the end of each valve stem two or three times with a plastic mallet to ensure proper seating of the valve and the valve cotters. Tap the valve stem only along its axis so you do not bend the valve stem.
NOTE: Be sure to raise the cylinder head off the work bench to avoid damaging the valve.
4. Camshaft - Install
5. Cylinder Head - Install
Special Tool Required

- Valve Spring Compressor Attachment 07757-PJ1010A

- Stem Seal Driver 07PAD-0010000
Was this page helpful?