ATF Warmer Removal and Installation
Removal/Installation
1. Vehicle - Lift
2. Engine Coolant - Drain
3. Front Bulkhead Cover - Remove
4. Air Intake Tube - Remove

5. Air Cleaner - Remove
6. Intake Air Duct - Remove
- Disconnect the breather pipe (A).

NOTE: When you tighten the band, refer to the throttle body removal and installation procedure.
7. ATF Warmer - Remove

- Disconnect the water bypass hoses (A).
NOTE: Be careful not to damage the lines when disconnecting the water bypass hoses.
- Disconnect the ATF hoses (B).
NOTE: Be careful not to damage the lines when disconnecting the ATF hoses.
- Turn the end of the ATF hoses up to prevent ATF from flowing out, then plug the hoses and the lines.

- Remove the ATF warmer (A).
8. All Removed Parts - Install
- Install the parts in the reverse order of removal.
NOTE:
- Make sure the ATF hoses and the clips are properly installed.
- If necessary, add ATF to the proper level.
ATF Warmer Removal and Installation
Removal
NOTE: Keep all foreign particles out of the transmission.
1. Vehicle - Lift
2. Splash Shield - Remove
3. ATF - Drain
4. Engine Coolant - Drain
5. Air Cleaner - Remove
6. Intake Air Guide - Remove
7. 12 Volt Battery - Remove
8. 12 Volt Battery Box - Remove

- Disconnect the connector (A).
9. 12 Volt Battery Duct - Remove
10.12 Volt Battery Base - Remove

- Remove the harness clamps (A).
11.Connector Bracket - Remove

12.ATF Warmer - Remove

- Disconnect the water bypass hoses (A).

- Remove the ATF warmer (A) with the fixing plates (B).
NOTE: Be careful not to damage the ATF warmer.

- Remove the pipes A and B with the fixing plates (C).
Installation
NOTE:
- Keep all foreign particles out of the transmission.
- Apply a light coat of clean ATF on all O-rings before installation.
1. ATF Warmer - Install

- Install new pipes A and B with new fixing plates (C) and new bolts (D).

- Install the ATF warmer (A) with new fixing plates (B) and new bolts (C).
NOTE: Be careful not to damage the ATF warmer.

- Connect the water bypass hoses (A), while aligning the paint marks (B) on the ATF warmer lines with the paint marks (C) on the water bypass hose ends.
- Secure the water bypass hoses with the clamps (D).

2. Connector Bracket - Install

3. 12 Volt Battery Base - Install

- Install the harness clamps (A).
4. 12 Volt Battery Duct - Install
5. 12 Volt Battery Box - Install

- Connect the connector (A).
6. 12 Volt Battery - Install
7. Intake Air Guide - Install
8. Air Cleaner - Install
9. Engine Coolant - Refill