Tailgate Release Actuator Test
In this manual: Tailgate Release Actuator Test
7steps
~42min
2/5difficulty
Done 0 of 7
Test
1. Tailgate Trim Panel - Remove
2. Tailgate Release Actuator - Test


- Disconnect the connector (A).
- Check the actuator operation by connecting power and ground according to the table.
NOTE: To prevent damage to the solenoid, apply battery voltage only momentarily.
- If the actuator does not actuate, the tailgate release actuator is faulty; replace the tailgate latch (B).
3. All Removed Parts - Install
- Install the parts in the reverse order of removal.
Tailpipe Emissions Test
Test
1. HDS - Connect
2. Tailpipe Emissions - Test
- Start the engine. Hold the engine speed at 3,000 rpm without load (in P or N) until the radiator fan comes on, then let it idle.
- Check the idle speed within specification.
- Warm up and calibrate the CO meter according to the meter manufacturer's instructions.
- Check idle CO with the headlights, heater blower, rear window defogger, cooling fan, and air conditioner off.
Specified CO: 0.1 % max..
- If unable to obtain this reading; see DTC troubleshooting.
- If unable to obtain a CO reading of specified % by this procedure, check the tune-up condition.
Was this page helpful?