Power Mirror Retract Actuator Removal and Installation
In this manual: Power Mirror Retract Actuator Removal and Installation
9steps
~54min
2/5difficulty
Done 0 of 9
Removal
1. Mirror Holder - Remove
2. Power Mirror Actuator - Remove
3. Mirror Housing Cover - Remove
4. Power Mirror - Remove
5. Power Mirror Retract Actuator - Remove
- Disassemble power mirror connector, then remove all the terminals (A) from the connector.

- Remove the gasket (A).

- Remove the grommet (B) and the harness clip (C).
- Pull out the harnesses (D) through the hole in the mirror sub assembly (E).
Installation
1. Power Mirror Retract Actuator - Install
- Route the wire harness (A) through the hole in the mirror sub assembly (B).

- Install the grommet (C).
- Install the harness clip (D).
- Install the gasket (E).
- Insert the mirror actuator wires into the terminal locations at the following as shown.
With LaneWatch

Without LaneWatch

- Install the harness (A).

2. Power Mirror - Install
3. Mirror Housing Cover - Install
4. Power Mirror Actuator - Install
5. Mirror Holder - Install
Was this page helpful?