Park Pin Switch Removal and Installation
In this manual: Park Pin Switch Removal and Installation
4steps
~24min
2/5difficulty
Done 0 of 4
Removal/Installation
NOTE: The park pin switch and the shift lock unit are not available separately. Remove the park pin switch and the shift lock unit as a set.
1. Shift Lock Unit - Remove
2. All Removed Parts - Install
- Install the parts in the reverse order of removal.
Parking and Back-Up Sensor Control Unit Removal and Installation
Removal/Installation
1. Parking and Back-Up Sensor Control Unit - Remove

- Loosen the TORX bolt (A) using a TORX E8 socket.
- Remove the parking and back-up sensor control unit (B) with the bracket (C).
- Disconnect the connector (D).
- Remove the bracket.
2. All Removed Parts - Install
- Install the parts in the reverse order of removal.
NOTE: If the bolt threads of the steering hanger beam are stripped, replace the bolts with one-size larger bolts (available as a service part), which are specifically designed to tighten the instrument panel to the specified torque setting.
Parking and Back-Up Sensor Switch Removal and Installation
Removal/Installation
1. Driver's Dashboard Lower Cover - Remove
2. Parking and Back-Up Sensor Switch - Remove

NOTE: The mounting position of the parking and back-up sensor switch (A) is different depending on the model.
3. All Removed Parts - Install
- Install the parts in the reverse order of removal.
Was this page helpful?