Rear Individual Map Light Removal, Installation, and Test
In this manual: Rear Individual Map Light Removal, Installation, and Test
6steps
~36min
2/5difficulty
Done 0 of 6
Removal/Installation
1. Rear Individual Map Light - Remove
Rear Individual Map Light: 5W

- Carefully pry off the lenses (A).
- Remove the bulbs (B).
- Remove the rear individual map light housing (C).
- Disconnect the connector (D).
2. All Parts Removed - Install
- Install the parts in the reverse order of removal.
Test
1. Rear Individual Map Light - Test


NOTE: When doing the rear individual map light test, make sure to install the bulbs correctly.
- Check for continuity between the terminals in each switch position according to the table.
- If the continuity is not as specified, replace the bulb(s) or the rear individual map light (A).
Rear Inner Fender Removal and Installation
Removal/Installation
1. Rear Wheel - Remove
2. Rear Inner Fender - Remove
- Canada models: Remove the rear splash guard (A).

3. All Removed Parts - Install
- Install the parts in the reverse order of removal.
Was this page helpful?