Mis-Fuel Inhibit Device Removal and Installation
In this manual: Mis-Fuel Inhibit Device Removal and Installation
2steps
~12min
1/5difficulty
Done 0 of 2
Removal/Installation
1. Mis-Fuel Inhibit Device - Remove

- Pry up the four lock tabs (A), and turn the mis-fuel inhibit device (B) about 90 degrees.

- Tilt the mis-fuel inhibit device (A) in the direction of the arrow to remove it from the fuel fill pipe.

NOTE: Be careful not to damage the fuel fill pipe or the fuel fill pipe top side surface (B).
2. All Removed Parts - Install

- Install the parts in the reverse order of removal.
NOTE: Align the part (A) on the new mis-fuel inhibit device (B) and the fuel fill pipe (C).
Was this page helpful?