Intermediate Shaft Removal and Installation
In this manual: Intermediate Shaft Removal and Installation
12steps
~72min
3/5difficulty
Done 0 of 12
Removal
1. Engine Undercover - Remove
2. Transmission Fluid - Drain
3. Right Driveshaft - Remove
4. Intermediate Shaft - Remove

- Remove the under-floor TWC.
- Remove the stiffener prate.
- Remove the heat shield bolts (A).

- Remove the intermediate shaft bolts (A).
- Remove the intermediate shaft and the heat shield assembly (B).
NOTE: Hold the intermediate shaft horizontal until it is clear of the differential to prevent damaging the oil seal (C).
Installation
1. Intermediate Shaft - Install

- Clean the areas where the intermediate shaft contacts the differential thoroughly with solvent.
NOTE: Do not wash the rubber parts with solvent.
- Dry the areas where the intermediate shaft contacts the differential thoroughly with compressed air.
- Apply Honda SPLINE WR GREASE (P/N 04360-5P8-305) to the intermediate shaft (A) as shown.
- Install the intermediate shaft and heat shield assembly (B).
NOTE: Insert the intermediate shaft carefully to prevent damaging the oil seal (C).

- Install the heat shield bolts (A).
- Install the under-floor TWC.
- Install the stiffener prate.
2. Right Driveshaft - Install
3. Intermediate Shaft - After Install Check
- Turn the wheel by hand, and make sure there is no interference between the driveshaft and surrounding parts.
4. Transmission Fluid - Refill
5. Wheel Alignment - Check
6. Test Drive - Check
Was this page helpful?