Evaporator Temperature Sensor Removal, Installation, and Test
In this manual: Evaporator Temperature Sensor Removal, Installation, and Test
4steps
~24min
2/5difficulty
Done 0 of 4
Removal/Installation

*1: Test item
1. Connector (Driver's Footwell Light)- Disconnect
2. Driver's Heater Duct B - Remove
3. Front Evaporator Temperature Sensor - Remove
4. All Removed Parts - Install
- Install the parts in the reverse order of removal.
Test
Front Evaporator Temperature Sensor
1. Front Evaporator Temperature Sensor - Test

- Dip the sensor in ice water, and measure the resistance between terminals No. 1 and No. 2.
- Then pour warm water on the sensor, and check for a change in resistance.
- Compare the resistance readings with the specifications shown in the graph; the resistance should be within the specifications.
- If the resistance is not as specified, replace the front evaporator temperature sensor.
Was this page helpful?