Engine Oil Jet Replacement
In this manual: Engine Oil Jet Replacement
4steps
~24min
2/5difficulty
Done 0 of 4
Replacement
1. Crankshaft - Remove
2. Oil Jet and Oil Jet Bolt - Remove

3. All Removed Parts - Install
- Install the parts in the reverse order of removal.
Engine Oil Level Check
Check
1. Engine Oil Level - Check

- Park the vehicle on level ground, and start the engine. Hold the engine speed at 3,000 rpm with no load (in P or N) until the radiator fan comes on, then turn off the engine, and wait more than 3 minutes.
- Remove the dipstick, and wipe off the dipstick, then reinstall the dipstick.
- Remove the dipstick, and check the engine oil level. It should be between the upper mark (A) and the lower mark (B).
- If the engine oil level is near or below the lower mark, check for oil leakage, and add engine oil to bring it to the upper mark.
Was this page helpful?