Heated Steering Wheel Switch Removal and Installation
In this manual: Heated Steering Wheel Switch Removal and Installation
5steps
~30min
2/5difficulty
Done 0 of 5
Removal/Installation
NOTE: SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.
1. Steering Wheel Trim- Remove

- Adjust the steering column to the full telescopic out position.
- Loosen the screws (A).
NOTE:
- Turn the steering wheel to the proper position to loosen the screws.
- The screws remains in the rear cover.
- Remove the driver's airbag.

- Pull out the steering wheel trim (A), then disconnect the connectors (B).
- Remove the steering wheel trim.
2. Heated Steering Wheel Switch - Remove

- Remove the set plate (A) and the heated steering wheel switch (B).
3. All Remove Parts - Install
- Install the parts in the reverse order of removal.
Heated Windshield Wiper Area Switch Removal and Installation
Removal and Installation
1. Driver's Dashboard Lower Cover - Remove
2. Heated Windshield Wiper Area Switch - Remove

NOTE: The mounting position of the heated windshield wiper area switch (A) is different depending on the model.
3. All Parts Removed - Install
- Install the parts in the reverse order of removal.
Was this page helpful?