A/T Differential Backlash Inspection
In this manual: A/T Differential Backlash Inspection
3steps
~18min
2/5difficulty
Done 0 of 3
Inspection
1. Final Driven Gear and Transfer Drive Gear - Remove
- With AWD: Remove the final driven gear and the transfer drive gear.
Without AWD: Remove the final driven gear.
2. Differential Backlash - Inspect

- Install both axles into the differential assembly (A).
- Place the axles on V-blocks (B).
- Measure the backlash of the pinion gears (C) with a dial indicator (D).
Standard: 0.05-0.15 mm (0.0020-0.0059 in)
- If the backlash is out of the standard, replace the differential assembly.
3. Final Driven Gear and Transfer Drive Gear - Install
- With AWD: Install the final driven gear and the transfer drive gear.
Without AWD: Install the final driven gear.
Was this page helpful?