Transfer Assembly Fluid Replacement
In this manual: Transfer Assembly Fluid Replacement
4steps
~24min
2/5difficulty
Done 0 of 4
Replacement
1. Vehicle - Lift
2. Transfer Assembly Fluid - Replace

- Remove the filler plug (A) with the sealing washer (B).
- Remove the drain plug (C) with the sealing washer (D), and drain the transfer assembly fluid.
- Reinstall the drain plug with a new sealing washer.
- Refill the transfer assembly with the recommended fluid through the filler hole (E) until the fluid flows out. Use an Honda HGO-1.
Transfer Assembly Fluid Capacity:
0.43 L (0.45 US qt) at fluid change
0.45 L (0.48 US qt) at overhaul
- Reinstall the filler plug with a new sealing washer.
Was this page helpful?