Dashlights Brightness Control Switch Test
In this manual: Dashlights Brightness Control Switch Test
~1min read
Test
1. Meter Visor - Remove
2. Dashlights Brightness Control Switch - Test


- Check for continuity between the terminals in each switch position according to the table.
NOTE:
- When an LED is located between terminals, check if the LED illuminates by connecting power and ground to the LED.
- Note this important operating characteristic; diode bias causes a diode to fully conduct electricity in one direction (forward), while not at all in the opposite direction (reverse).
- If the continuity is not as specified, replace the dashlights brightness control switch (A).
3. All Removed Parts - Install
- Install the parts in the reverse order of removal.
Was this page helpful?