Front Seat-Back Cover Removal and Installation
In this manual: Front Seat-Back Cover Removal and Installation
12steps
~72min
3/5difficulty
Done 0 of 12
Removal and Installation
NOTE: SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.
1. Front Seat - Remove
2. Front Seat Armrest - Remove
3. Front Seat-Back Cover/Pad - Remove
Driver's seat

Passenger's seat

- Release the hooks (A).
- Remove the harness clips (B). (with side airbag)
- Disconnect the connector (C). (passenger's seat)

- Release the hook strips (A), and unzip the seat-back cover (B).

- Release the hook strips (A), and then remove the clips.

- Disconnect the connector (A). (with seat heater)
- Remove the harness clip (B). (with side airbag)
- Remove the nuts. (with side airbag)
- Pull out the harness (C), out through the seat-cushion cover ring (D). (with side airbag)

- Remove the seat back blower lower duct (A) from the seat back blower upper duct (B). (with ventilated seat)

- Remove the head restraint guides (A).

- Remove the seat-back cover/pad (A).
NOTE: Pull out the harness (B), out through the seat frame hole (C).

- Remove the nuts (A), and then remove the side airbag (B).
4. Front Seat-Back Cover - Remove
With ventilated seat

Without ventilated seat

- Remove the upholstery rings (A) and fasteners (B), and then remove the seat-back cover (C).
5. All Removed Parts - Install

Was this page helpful?