SRS Unit Removal and Installation
In this manual: SRS Unit Removal and Installation
2steps
~12min
1/5difficulty
Done 0 of 2
Removal/Installation
SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.
1. 12 Volt Battery Terminal - Disconnect
NOTE: Wait at least 3 minutes before starting work.
2. Center Console Side Cover - Remove
3. SRS Unit - Remove
- Disconnect the connectors (A).
NOTE: The SRS unit connectors have lever locks. Release the locks before disconnecting the connectors.

- Remove the bolts (B).
- Remove the SRS unit (C).
4. All Removed Parts - Install
- Install the parts in the reverse order of removal.
NOTE:
- During installation, install the new bolts to the specified torque.
- Before installing the center console, make sure the SRS indicator works normally.
- Make sure the SRS unit has the latest software. If it does not have the latest, update the software in the SRS unit.
5. SRS Operation - Confirm
- Do the 12 volt battery terminal reconnection procedure, turn the vehicle to the ON mode, and check that the SRS indicator comes on for about 6 seconds and then goes off.
Was this page helpful?