TCM Removal and Installation
In this manual: TCM Removal and Installation
4steps
~24min
2/5difficulty
Done 0 of 4
Removal
CAUTION
Before following the procedure, be sure to observe precautions and eliminate static electricity.
1. Air Cleaner - Remove
2. TCM - Remove

- Disconnect the connector (A) by pushing the lock (B) and pulling the lever (C) up.
- Remove the TCM (D).
Installation
CAUTION
Before following the procedure, be sure to observe precautions and eliminate static electricity.
NOTE:
- If you only remove the TCM, skip the Procedure After Replacing TCM.
- If you replace the TCM, you must done all procedures below.
1. TCM - Install

- Install the TCM (A).
- Connect the connector (B), and lock the connector by pulling the lever (C) down.
NOTE: When connecting the connector, check for corrosion, dirt, or oil, and clean or repair if necessary.
2. Air Cleaner - Install
Procedure After Replacing TCM
3. Keyless Access System - Register (Without Electric Steering Lock)
4. TCM - Update
5. Hydraulic Pressure Characteristic - Calibrate
Was this page helpful?