Rear Brake Pad Inspection
In this manual: Rear Brake Pad Inspection
~1min read
Inspection
CAUTION
Frequent inhalation of brake pad dust, regardless of material composition, could be hazardous to your health.
- Avoid breathing dust particles.
- Never use an air hose or brush to clean brake assemblies. Use an OSHA-approved vacuum cleaner.
1. Vehicle - Lift
2. Rear Wheels - Remove
3. Rear Brake Pad - Inspect

- Check the thickness (A) of the inner pad (B) and the outer pad (C). Do not include the thickness of the backing plate.
Brake pad thickness:
Standard: 10.0 mm (0.394 in)
Service limit: 1.6 mm (0.063 in)
- If any part of the brake pad thickness is less than the service limit, replace the brake pads as a set.
4. Rear Wheels -Install
Was this page helpful?