Rocker Arm Oil Pressure Sensor Removal and Installation
In this manual: Rocker Arm Oil Pressure Sensor Removal and Installation
5steps
~30min
2/5difficulty
Done 0 of 5
Removal
1. Vehicle - Lift
2. Rocker Arm Oil Pressure Sensor - Remove

- Disconnect the connector (A).
- Remove the rocker arm oil pressure sensor.
- Remove any old liquid gasket from the switch and the switch mounting hole.
Installation
1. Rocker Arm Oil Pressure Sensor - Install

- Apply liquid gasket (P/N 08718-0003, 08718-0004, or 08718-0009) to the rocker arm oil pressure sensor threads.
Install the component within 5 minutes of applying the liquid gasket.
NOTE:
- Using too much liquid gasket may cause liquid gasket to enter the oil passage or the end of the rocker arm oil pressure sensor.
- If too much time has passed after applying the liquid gasket, remove the old liquid gasket and residue, then reapply new liquid gasket.
- Install the rocker arm oil pressure sensor with a new O-ring.
- Connect the connector (A).
Was this page helpful?