Wheel Bearing End Play Inspection
In this manual: Wheel Bearing End Play Inspection
6steps
~36min
2/5difficulty
Done 0 of 6
Inspection
1. Vehicle - Lift
2. Front Wheels and Rear Wheels - Remove
3. Wheel Bearing End Play - Inspect

- Install suitable flat washers (A).
- Install the wheel nuts (B).
- Tighten the nuts to the specified torque to hold the brake disc or the brake disc/drum securely against the hub.
- Attach the dial gauge (C).
- Place the dial gauge against the hub flange.
- Measure the bearing end play while moving the brake disc or the brake disc/drum inward and outward.
Wheel bearing end play:
Front/Rear: 0-0.05 mm (0-0.0020 in)
- If the bearing end play measurement is more than the standard, replace the wheel bearing or the hub bearing unit.
- Front wheel bearing.
- Rear hub bearing unit.
4. Front Wheels and Rear Wheels - Install
Was this page helpful?