Torque Converter Housing Idler Gear Shaft Bearing Replacement
In this manual: Torque Converter Housing Idler Gear Shaft Bearing Replacement
3steps
~18min
2/5difficulty
Done 0 of 3
Replacement
1. Idler Gear Shaft Bearing - Remove

- Remove the idler gear shaft bearing (A) using the 25 mm bearing remover, the remover handle, and the slide hammer.

NOTE: Be careful not to damage the ATF guide plate (B) when setting the tip (C) of the 25 mm bearing remover.

- Remove the ATF guide plate (A), and replace it if it is damaged.
2. Idler Gear Shaft Bearing - Install

- Install the ATF guide plate (A).

- Install the idler gear shaft bearing (A).

- Drive the idler gear shaft bearing until it bottoms using the 15 x 135L driver handle and the 52 x 55 mm bearing driver attachment.
Special Tool Required

- Bearing Driver Attachment, 52 x 55 mm 07746-0010400

- Driver Handle, 15 x 135L 07749-0010000

- Remover Handle 07936-3710100

- Slide Hammer 07936-371020A

- Bearing Remover, 25 mm 07936-ZV1A100
Was this page helpful?