Pulley End Crankshaft Oil Seal Replacement - In Car
In this manual: Pulley End Crankshaft Oil Seal Replacement - In Car
4steps
~24min
2/5difficulty
Done 0 of 4
Replacement
1. Timing Belt Drive Pulley - Remove
2. Pulley End Crankshaft Oil Seal - Remove

3. Pulley End Crankshaft Oil Seal - Install

- Clean and dry the crankshaft oil seal housing.
- Apply a light coat of new engine oil to the lip of the pulley end crankshaft oil seal.
- Using the oil seal driver, 64 mm, drive in the new pulley end crankshaft oil seal (A) until the oil seal driver bottoms on the oil pump.
- Clean the excess oil off the crankshaft, and check that the pulley end oil seal lip is not distorted.
4. All Removed Parts - Install
- Install the parts in the reverse order of removal.
Special Tool Required

- Oil Seal Driver, 64 mm 070AD-RCAA100
Was this page helpful?