Steering Gearbox Mount Cushion Replacement
In this manual: Steering Gearbox Mount Cushion Replacement
6steps
~36min
2/5difficulty
Done 0 of 6
Replacement
NOTE: Do not allow dust, dirt, or other foreign materials to enter the steering gearbox.
1. Steering Gearbox - Remove
2. Steering Gearbox Mount Cushion - Remove

- Position a 41 mm socket (A) on the flange part of the gearbox housing with a washer (B), a 10 x 105 mm flange bolt (C), and a 10 mm nut (D) as shown.
- Hold the flange bolt with a wrench, and tighten the nut with a wrench.
- Remove the gearbox mount cushion (E).
3. Steering Gearbox Mount Cushion - Install

- Apply a mild soap and water solution to the new gearbox mount cushion surface (A), then place the mount cushion on the gearbox mounting cushion hole.
- Position a 41 mm socket (B) on the flange part of the gearbox housing with a washer (C), a flange bolt (D), and a nut (E) as shown.

- Install the gearbox mount cushion by tightening the nut until the mount cushion edges (A) properly fits on the gearbox flange surfaces (B).
4. Steering Gearbox - Install
Was this page helpful?