Shift Lock Solenoid Test
In this manual: Shift Lock Solenoid Test
6steps
~36min
2/5difficulty
Done 0 of 6
Test
NOTE: The shift lock solenoid and the shift lock unit are not available separately. Remove the shift lock solenoid and the shift lock unit as a set.
1. HDS DLC - Connect
2. Shift Lock Solenoid - Test
- Select the Shift Lock Solenoid Test in the Miscellaneous Test Menu, and check that the shift lock solenoid operates with the HDS.
- Check that the shift lever can be moved out of P when the Shift Lock Solenoid is ON. Move the shift lever back to P, and check that it locks when the Shift Lock Solenoid is OFF.
- Check that the shift lock releases when the shift lock release is pushed, and check that it locks when the shift lock release is released.
- If the shift lock solenoid does not work properly, go to the shift lock system circuit troubleshooting.
Shift Solenoid Valve A and B Test
Test
1. HDS DLC - Connect
2. Shift Solenoid Valve - HDS Function Test
- Select Shift Solenoid Valve A or B in the Miscellaneous Test Menu with the HDS.
- Check that shift solenoid valve A or B operates with the HDS. A clicking sound should be heard.
- If a clicking sound is heard, the solenoid valve is OK.
The test is complete, disconnect the HDS.
- If no clicking sound is heard, go to the next step, and test the shift solenoid valve.
- If a clicking sound is heard, the solenoid valve is OK.
3. Secondary Valve Body - Remove
4. Shift Solenoid Valve - Resistance Check

- Measure the resistance of shift solenoid valves A and B between connector terminals No. 1 and No. 2.
Standard: 13.8-17.1 Ω
- If the resistance is out of the standard, replace the secondary valve body.
- If the resistance is within the standard, go to the next step, and check the shift solenoid valve operation.
5. Shift Solenoid Valve - Operation Check
- Connect a jumper wire from the positive battery terminal to shift solenoid valve A or B connector terminal No. 1, and connect another jumper wire from the negative battery terminal to connector terminal No. 2.
- If a clicking sound is heard, repair the wire between the defective shift solenoid valve and the PCM, then go to the next step, and install the secondary valve body.
- If no clicking sound is heard, replace the secondary valve body.
6. Secondary Valve Body - Install
Was this page helpful?