Tailgate Spoiler Trim Removal and Installation
In this manual: Tailgate Spoiler Trim Removal and Installation
6steps
~36min
2/5difficulty
Done 0 of 6
Removal/Installation
1. Tailgate Upper Trim Panel - Remove
2. Tailgate Side Trim - Remove
3. Tailgate Spoiler Trim - Remove
With Power Tailgate

Without Power Tailgate

- Remove the bolts (A, B) securing the tailgate spoiler trim (C).
NOTE: Remove the wire harness grommets (D) as needed.
- Disconnect the connector (E).

- Release the outer tailgate spoiler trim clips with the clip release tool.
- Insert the clip release tool through the access hole in the tailgate.
- Position the clip release tool over the clip, and then carefully pull down on the tool's handle to release the clip.
- The illustration shows the left side. Perform the same procedure for the right side.

- Carefully pull up the tailgate spoiler trim (A) to remove the clips (B) and to release the pins (C) of the clips (D) from the grommets (E).
NOTE: The grommets will stay in the tailgate.
- Disconnect the washer tube (F).
- Remove the wire harness grommet (G) from the tailgate.
4. All Removed Parts - Install
- Install the parts in the reverse order of removal.
Special Tool Required

- Clip Release Tool 07AAE-TZ5A100
Was this page helpful?