Output Shaft (Countershaft) Speed Sensor Removal and Installation
In this manual: Output Shaft (Countershaft) Speed Sensor Removal and Installation
2steps
~12min
1/5difficulty
Done 0 of 2
Removal/Installation
1. Front Bulkhead Cover - Remove
2. Air Intake Tube - Remove

3. Air Cleaner - Remove
4. 12 Volt Battery - Remove
5. 12 Volt Battery Box - Remove

- Disconnect the connector (A).
6. 12 Volt Battery Duct - Remove
7. Battery Base - Remove

- Remove the harness clamps (A).
8. Output Shaft (Countershaft) Speed Sensor - Remove

- Disconnect the connector (A).
- Remove the output shaft (countershaft) speed sensor (B) with the O-ring (C).
9. All Removed Parts - Install
- Install the parts in the reverse order of removal.
NOTE:
- Check the connector for corrosion, dirt, or oil, and clean or repair if necessary
- Be sure to use a new O-ring when installing output shaft (countershaft) speed sensor.
- If necessary, add ATF to the proper level.
Was this page helpful?