Heated Steering Wheel Control Unit Removal and Installation
In this manual: Heated Steering Wheel Control Unit Removal and Installation
5steps
~30min
2/5difficulty
Done 0 of 5
Removal/Installation
NOTE: SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.
1. Steering Wheel Trim- Remove

- Adjust the steering column to the full telescopic out position.
- Loosen the screws (A).
NOTE:
- Turn the steering wheel to the proper position to loosen the screws.
- The screws remains in the rear cover.
- Remove the driver's airbag.

- Pull out the steering wheel trim (A), then disconnect the connectors (B).
- Remove the steering wheel trim.
2. Heated Steering Wheel Control Unit - Remove

3. All Remove Parts - Install
- Install the parts in the reverse order of removal.
Was this page helpful?