Brake Hose Removal and Installation
In this manual: Brake Hose Removal and Installation
14steps
~84min
3/5difficulty
Done 0 of 14
Removal
NOTICE
Do not spill brake fluid on the vehicle; it may damage the paint. If brake fluid gets on the paint, wash it off immediately with water.
NOTE: After removal, plug the ends of the hoses and the joints to prevent spilling brake fluid.
Front
1. Vehicle - Lift
2. Front Wheel - Remove
3. Front Brake Hose - Remove

- Disconnect the brake line (A) from the brake hose (B).
- Remove the brake hose clip (C).
- Remove the banjo bolt (D), and disconnect the brake hose from the caliper body.
Rear
1. Vehicle - Lift
2. Rear Wheel - Remove
3. Rear Brake Hose - Remove

- Disconnect the brake line (A) from the brake hose (B).
- Remove the brake hose clip (C).
- Remove the banjo bolt (D), and disconnect the brake hose from the caliper body.
Installation
NOTICE
Do not spill brake fluid on the vehicle; it may damage the paint. If brake fluid gets on the paint, wash it off immediately with water.
Front
1. Front Brake Hose - Install

NOTE:
- Check that all parts are free of dirt and other foreign particles.
- Replace parts with new ones whenever specified to do so.
- Install the brake hose (A) with the brake hose mounting bolt (B).
- Connect the brake hose to the caliper body with the banjo bolt (C) and new sealing washers (D).
- Install the new brake hose clip (E) to the brake hose.
- Connect the brake line (F) to the brake hose.
2. Brake System - Bleed
3. Brake Hose and Line - Check
NOTE:
- Check for leaks at hose and line joints or connections, and retighten if necessary.
- Check the brake hoses for interference and twisting.
4. Front Wheels - Install
Rear
1. Rear Brake Hose - Install

NOTE:
- Check that all parts are free of dirt and other foreign particles.
- Replace parts with new ones whenever specified to do so.
- Install the brake hose (A) with the brake hose mounting bolt (B).
- Connect the brake hose to the caliper body with the banjo bolt (C) and new sealing washers (D).
- Install the new brake hose clip (E) to the brake hose.
- Connect the brake line (F) to the brake hose.
2. Brake System - Bleed
3. Brake Hose and Line - Check
NOTE:
- Check for leaks at hose and line joints or connections, and retighten if necessary.
- Check the brake hoses for interference and twisting.
4. Rear Wheel - Install
Was this page helpful?