Parking Brake Inspection
In this manual: Parking Brake Inspection
7steps
~42min
2/5difficulty
Done 0 of 7
Inspection
CAUTION
Frequent inhalation of brake pad dust, regardless of material composition, could be hazardous to your health.
- Avoid breathing dust particles.
- Never use an air hose or brush to clean brake assemblies. Use an OSHA-approved vacuum cleaner.
1. Vehicle - Lift
2. Rear Wheels - Remove
3. Rear Brake Disc/Drum - Remove
4. Parking Brake - Inspect

- Check the parking brake linings (A) for cracking, glazing, wear, and contamination.
- Measure the parking brake lining thickness (B).
Measurement does not include brake shoe thickness.
Parking brake lining thickness:
Standard: 3.9 mm (0.154 in)
Service limit: 1.0 mm (0.039 in)
- If any part of the parking brake lining thickness is less than the service limit, replace all of the parking brake shoes as a set.
- Check the hub (C) for smooth operation. If it requires servicing, replace the hub bearing unit.

- Measure the inside diameter of the parking brake drum with an inside vernier caliper.
Parking brake drum inside diameter:
Standard: 210.0 mm (8.268 in)
Service limit: 211.0 mm (8.307 in)
- If the inside diameter of the parking brake drum is more than the service limit, replace the brake disc/drum.
- Check the parking brake disc/drum for scoring, grooves, and cracks.
5. Rear Brake Disc/Drum - Install
6. Parking Brake - Adjust
7. Rear Wheels - Install
Was this page helpful?