Dashlights Brightness Control Switch Removal and Installation
In this manual: Dashlights Brightness Control Switch Removal and Installation
3steps
~18min
2/5difficulty
Done 0 of 3
Removal/Installation
1. Meter Visor - Remove
2. Dashlights Brightness Control Switch - Remove

- Remove the dashlights brightness control switch (A).
3. All Removed Parts - Install
- Install the parts in the reverse order of removal.
DC-DC Converter Removal and Installation
Removal/Installation
SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.
1. Driver's Heater Duct B - Remove
2. DC-DC Converter - Remove

- Disconnect the connectors (A).
- Loosen or remove the DC-DC converter mounting nuts (B).
- Remove the DC-DC converter (C).
3. All Removed Parts - Install
- Install the parts in the reverse order of removal.
Defogger Vent Trim Removal and Installation
Removal and Installation
1. Defogger Vent Trim - Remove

NOTE: The driver's side is shown; the passenger's side is similar.
2. All Removed Parts - Install
- Install the parts in the reverse order of removal.
Was this page helpful?