Power Relay Test
In this manual: Power Relay Test
~2min read
Test
1. Power Relay - Test
Use this chart to identify the types of the relay, then do the test listed for it.
| Relay | Test |
| A/C compressor clutch relay* | Normally-open four-terminal type |
| A/C condenser fan relay* | |
| Active control engine mount (ACM) control relay* | |
| Cargo area accessory power socket relay* | |
| Console accessory power socket relay* | |
| DC-DC converter ACC relay* | |
| DC-DC converter IG1 relay 1* | |
| DC-DC converter IG1 relay 2* | |
| Driver's seat heater relay (HIGH)* | |
| Front accessory power socket relay* | |
| Front blower motor relay* | |
| Front fog light relay* | |
| Front passenger's seat heater relay (HIGH)* | |
| Fuel fill door opener solenoid relay* | |
| Headlight relay* | |
| Heated steering wheel relay* | |
| Heated windshield wiper area relay* | |
| Horn relay* | |
| IG1A relay* | |
| IG1B relay* | |
| Injector relay* | |
| Interior lights cut relay* | |
| i-VTM relay* (AWD) | |
| Left second row seat with one-touch access relay* | |
| PGM-FI main relay 2* | |
| Power tailgate relay* | |
| Power window relay* | |
| Radiator fan relay* | |
| Rear accessory power socket relay* | |
| Rear blower motor relay* | |
| Rear window defogger relay* | |
| Rear window wiper motor relay* | |
| Right second row seat with one-touch access relay* | |
| Second row seat heater relay* | |
| Starter cut relay 1* | |
| Starter cut relay 2* | |
| Ventilated seat relay* | |
| Brake light relay* | Five-terminal type |
| Driver's seat heater relay (LOW)* | |
| Fan control relay* | |
| Front passenger's seat heater relay (LOW)* | |
| Rear window washer motor relay* | |
| Windshield washer motor relay* |
*: Carefully remove the relay using the special relay puller tool. Do not use pliers. Pliers will damage the relay.

Normally-Open Four-Terminal Type
Check for continuity between the terminals:
- There should be continuity between terminals No. 1 and No. 2 when 12 volt battery power is connected to terminal No. 3, and 12 volt battery ground is connected to terminal No. 4.
- There should be no continuity between terminals No. 1 and No. 2 when 12 volt battery power is disconnected.


Five-Terminal Type
Check for continuity between the terminals:
- There should be continuity between terminals No. 1 and No. 2 when 12 volt battery power is connected to terminal No. 3, and 12 volt battery ground is connected to terminal No. 5.
- There should be continuity between terminals No. 1 and No. 4 when 12 volt battery power is disconnected.


Special Tool Required

- Relay Puller 07AAC-000A2A1 or 07AAC-000A1A0

- Relay Socket Extension (5 Pin) 07AGK-000A2A0

- Relay Socket Extension (4 Pin) 07AGK-000A1A0
Was this page helpful?