Rear License Trim Removal and Installation
In this manual: Rear License Trim Removal and Installation
2steps
~12min
1/5difficulty
Done 0 of 2
Removal/Installation
1. Tailgate Lower Trim Panel - Remove
2. Tailgate Outer Handle/Lock Switch - Remove
3. Rear License Trim - Remove

- Remove the left rear license trim (A) and right rear license trim (B).
- Disconnect the connectors (C).
4. All Removed Parts - Install
- Install the parts in the reverse order of removal.
Rear Lower Arm A Removal and Installation
Removal/Installation
1. Vehicle - Lift
2. Rear Wheel - Remove
3. Lower Arm A - Remove

NOTE: Use the new flange bolts during reassembly.
4. All Removed Parts - Install
- Install the lower arm A in the reverse order of removal, and note these items:
- Loosely install nuts and/or bolts to secure the bushings.
Load the suspension with the vehicle's weight and tighten the nuts and/or bolts to the specified torque.
- Before installing the wheel, clean the mating surfaces on the brake disc/drum and the inside of the wheel.
- Loosely install nuts and/or bolts to secure the bushings.
5. Wheel Alignment - Check
Was this page helpful?