Front Passenger's Weight Sensor Unit Removal and Installation
In this manual: Front Passenger's Weight Sensor Unit Removal and Installation
2steps
~12min
1/5difficulty
Done 0 of 2
Removal/Installation
SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.
1. 12 Volt Battery Terminal - Disconnect
NOTE: Wait at least 3 minutes before starting work.
2. Front Passenger's Weight Sensor Unit - Remove

- Disconnect the connectors (A).
- Remove the front passenger's weight sensor unit (B) from the bracket (C).
NOTE: While separating the front passenger's weight sensor unit from the bracket, use a flat-tipped screwdriver (D) to push and release it from the bracket.
3. All Removed Parts - Install
- Install the all removed parts in the reverse order of removal.
NOTE:
- Make sure the front passenger's weight sensor unit is properly installed. You will hear a click when the front passenger's weight sensor unit is securely mounted on the bracket.
- Make sure the front passenger's weight sensor unit has the latest software. If it does not have the latest, update the software in the front passenger's weight sensor unit.
- After replacing the front passenger's weight sensor unit with a new one, initialize the front passenger's weight sensor unit.
4. SRS Operation - Confirm
Front Pillar Corner Trim Removal and Installation
Removal/Installation
1. Front Pillar Corner Trim - Remove

2. All Removed Parts - Install
- Install the parts in the reverse order of removal.
Was this page helpful?