Front Brake Disc Removal and Installation
In this manual: Front Brake Disc Removal and Installation
2steps
~12min
1/5difficulty
Done 0 of 2
Removal/Installation
NOTE: Keep grease away from the brake disc and the brake pads.
1. Vehicle - Lift
2. Front Wheel - Remove
3. Front Brake Caliper - Remove

- Remove the brake hose mounting bolt (A).
- Remove the caliper assembly (B).
NOTE:
- To prevent damage to the caliper assembly or brake hose, use a short piece of wire to hang the caliper assembly from the undercarriage.
- Do not twist the brake hose excessively.
4. Front Brake Disc - Remove

- Remove the brake disc (A).
NOTE: If the brake disc is stuck to the front hub, thread two 8 x 1.25 mm bolts (B) into the brake disc to push it away from the front hub. Turn each bolt 90 degrees at a time to prevent the brake disc from binding.
5. All Removed Parts - Install
- Install the brake disc in the reverse order of removal.
NOTE: Before installing the brake disc, clean the mating surfaces between the hub bearing unit and the inside of the brake disc.
6. Front Brake Disc Runout - Inspect
Was this page helpful?