Washer Fluid Level Switch Removal, Installation, and Test
In this manual: Washer Fluid Level Switch Removal, Installation, and Test
4steps
~24min
2/5difficulty
Done 0 of 4
Removal/Installation
1. Front Inner Fender - Remove
- Remove the front inner fender as needed.
2. Washer Fluid Level Switch - Remove

- Disconnect the connector.
- Remove the washer fluid level switch (A).
NOTE: Fluid may flow out of the opening.
3. All Removed Parts - Install
- Install the parts in the reverse order of removal.
Test
1. Washer Fluid Level Switch - Test

- Check for continuity between the terminals in each switch position according to the table.
- If the continuity is not as specified, replace the washer fluid level switch (A).
Was this page helpful?