Side Engine Mount Removal and Installation
In this manual: Side Engine Mount Removal and Installation
2steps
~12min
1/5difficulty
Done 0 of 2
Removal/Installation
1. 12 Volt Battery Terminal - Disconnect
2. Engine - Support
- Lift and support the engine with a jack and a wood block under the oil pan.
3. Upper Half of Side Engine Mount Bracket - Remove

- Disconnect the ground cable (A).
- Remove the harness clamp bracket (B) and the upper half of side engine mount bracket.
4. VSA Modulator-Control Unit with Bracket - Move
NOTE: Do not disconnect the brake lines.
5. Side Engine Mount - Remove

6. All Removed Parts - Install
- Install the parts in the reverse order of removal.
NOTE:
- Do the mounts tightening procedure before tightening all of the mounts' bolts and nuts.
- Install the VSA modulator-control unit with bracket after tightening the side engine mount mounting bolts.
Was this page helpful?