Power Lumbar Support Switch Removal and Installation
In this manual: Power Lumbar Support Switch Removal and Installation
5steps
~30min
2/5difficulty
Done 0 of 5
Removal/Installation
1. Front Seat Recline Cover - Remove
NOTE: If you are removing the front seat recline cover, you do not need to remove the front seat.
2. Power Lumbar Support Switch - Remove

3. All Parts Removed - Install
- Install the parts in the reverse order of removal.
Power Mirror Actuator Removal and Installation
Removal/Installation
1. Mirror Holder - Remove
2. Power Mirror Actuator - Remove

- Remove the screws with a TORX T15 bit.
- Remove the power mirror actuator (A).
- Disconnect the connectors (B).
3. All Removed Parts - Install
- Install the parts in the reverse order of removal.
Power Mirror Control Unit Removal and Installation
Removal/Installation
1. Driver's Door Panel - Remove
2. Power Mirror Control Unit - Remove

- Disconnect the connector (A).
- Remove the power mirror control unit (B).
3. All Removed Parts - Install
- Install the parts in the reverse order of removal.
Was this page helpful?