Panoramic Glass Roof Sunshade Removal and Installation
In this manual: Panoramic Glass Roof Sunshade Removal and Installation
12steps
~72min
3/5difficulty
Done 0 of 12
Removal/Installation
NOTE: SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.
1. Headliner - Remove
2. Sunshade Motor - Remove
3. Sunshade Frame - Remove
4. Sunshade Trim - Remove
5. Sunshade - Remove

- Remove the harness clips (A, B).
- Disconnect the sunshade cable tube (C) from the sunshade frame (D).( both side)

- Remove the screws.

- Remove the sunshade cable assembly (A) and the sunshade plate (B) from the sunshade frame (C).
NOTE: Remove the tension guide (D) from the tension guide rail (E) of the sunshade frame.

- Remove the sunshade cable assembly (A) from the sunshade plate (B).

- Remove the sunshade cable (A) from the sunshade slider (B).
- Release the tension guide (C) from the sunshade slider hooks (D).

- Release the tension guide (A) from the rail guide (B).

- Remove the sunshade holder (A) from the sunshade (B).

- Remove the sunshade cable assembly (A) from the sunshade (B).
NOTE: Firmly hold the sunshade with both hands; otherwise the wind-up force will be transferred to the shade.
- Remove the sunshade holder (C) from the sunshade cable (D) and the sunshade cable tube (E).

- Remove the guide pin (A) from the sunshade (B).
6. All Removed Parts - Install

- Install the parts in the reverse order of removal.
NOTE: Adjustment the wind-up force, rotate the sunshade guide pin (A) 20 revolutions as shown.
7. Sunshade Control Unit - Reset
Was this page helpful?