LaneWatch Camera Removal and Installation
In this manual: LaneWatch Camera Removal and Installation
5steps
~30min
2/5difficulty
Done 0 of 5
Removal and Installation
1. Ritht Side Mirror Visor - Remove
2. LaneWatch Camera - Remove

- Disconnect the connector (A).
- Remove the camera cover (B).

- Remove the LaneWatch camera (A).
3. All Removed Parts - Install
- Install the parts in the reverse order of removal.
LaneWatch Switch Removal, Installation, and Test
Removal/Installation
SRS components are located in this area. Review the SRS component locations, and the precautions and procedures before doing repairs or service.
1. Combination Light Switch - Remove
2. All Removed Parts - Install
- Install the parts in the reverse order of removal.
Test
1. LaneWatch Switch - Test

- On the switch side, check for continuity between the combination light switch 12P connector terminals in each switch position according to the table.
- If the continuity is not as specified, replace the combination light switch.
Was this page helpful?