Heated Steering Wheel Switch Test
In this manual: Heated Steering Wheel Switch Test
~1min read
Test
NOTE: SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.
1. Steering Wheel Trim - Remove
2. Heated Steering Wheel Switch - Test


- Check for continuity between the terminals in each switch position according to the table.
NOTE:
- When an LED is located between terminals, check if the LED illuminates by connecting power and ground to the LED.
- Note this important operating characteristic; diode bias causes a diode to fully conduct electricity in one direction (forward), while not at all in the opposite direction (reverse).
- If the result is not as specified, replace the heated steering wheel switch (A).
3. All Remove Parts - Install
- Install the parts in the reverse order of removal.
Was this page helpful?