Cylinder Head Inspection for Warpage
In this manual: Cylinder Head Inspection for Warpage
~1min read
Inspection
1. Cylinder Head - Remove
2. Camshaft - Remove
3. Cylinder Head Warpage - Inspect

- Check the cylinder head for warpage. Measure along the edges, and three ways across the center:
- If warpage is less than 0.05 mm (0.002 in), cylinder head resurfacing is not required.
- Maximum resurface is limited to the cylinder head height standard as shown.
Cylinder Head Warpage
Standard (New): 0.05 mm (0.002 in) max.
Cylinder Head Height
Standard (New): 120.95-121.05 mm (4.7618- 4.7657 in)
4. All Removed Parts - Install
- Install the parts in the reverse order of removal.
Was this page helpful?