Water Passage Removal and Installation
In this manual: Water Passage Removal and Installation
2steps
~12min
1/5difficulty
Done 0 of 2
Removal/Installation
1. Engine Coolant - Drain
2. Starter - Remove (9-Speed A/T)
3. Intake Manifold - Remove
4. Thermostat - Remove
5. EGR Pipe A - Remove
6. EGR Valve - Remove
7. ECT Sensor 1 - Remove
8. High Pressure Fuel Pump Cover - Remove

9. Upper Radiator Hose, Heater Hose, and Water Bypass Hose - Disconnect
6-Speed A/T

9-Speed A/T

- Disconnect the upper radiator hose (A), the heater hoses (B), and the water bypass hoses (C).
10.Water Passage - Remove

11.Connecting Pipe - Remove

- 6-Speed A/T: Disconnect the heater hose (A) and the water bypass hose (B).
- Remove the connecting pipe as needed.
12.All Removed Parts - Install
- Install the parts in the reverse order of removal.
NOTE:
- If the connecting pipe is removed, install the connecting pipe.
- After installing all the removed parts, refill the radiator with engine coolant, and bleed the air from the cooling system.
Water Pump Removal and Installation
Removal/Installation
1. Engine Coolant - Drain
2. Timing Belt - Remove
3. Timing Belt Adjuster - Remove
4. Water Pump - Remove

5. All Removed Parts - Install
- Install the parts in the reverse order of removal.
NOTE:
- Inspect and clean the O-ring groove and the mating surface of the engine block.
- After installing all the removed parts, refill the radiator with engine coolant, and bleed the air from the cooling system.
Was this page helpful?