Transmission Fluid Pressure Switch C (4th Clutch) Removal and Installation
In this manual: Transmission Fluid Pressure Switch C (4th Clutch) Removal and Installation
2steps
~12min
1/5difficulty
Done 0 of 2
Removal/Installation
1. Vehicle - Lift
2. Splash Shield - Remove
3. Transmission Fluid Pressure Switch C (4th Clutch) - Remove

- Disconnect the connector (A).
- Remove transmission fluid pressure switch C (4th clutch) with the sealing washer (B).
4. All Removed Parts - Install
- Install the parts in the reverse order of removal.
NOTE:
- Check the connector for corrosion, dirt, or oil, and clean or repair if necessary.
- Be sure to use a new sealing washer when installing transmission fluid pressure switch C (4th clutch) .
- Tighten the switch by gripping the metal part, not the plastic part.
- If necessary, add ATF to the proper level.
Was this page helpful?