Side Impact Sensor (Second) Removal and Installation
In this manual: Side Impact Sensor (Second) Removal and Installation
2steps
~12min
1/5difficulty
Done 0 of 2
Removal/Installation
SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.
1. 12 Volt Battery Terminal - Disconnect
NOTE: Wait at least 3 minutes before starting work.
2. Rear Side Trim Panel - Remove
3. Side Impact Sensor (Second) - Remove

- Disconnect the connector (A).
- Remove the bolt (B), then remove the side impact sensor (second) (C).
4. All Removed Parts - Install
- Install the parts in the reverse order of removal.
NOTE:
- During installation, install the new bolt to the specified torque.
- Before installing the rear side trim panel, make sure the SRS indicator works normally.
5. SRS Operation - Confirm
- Do the 12 volt battery terminal reconnection procedure, turn the vehicle to the ON mode, and check that the SRS indicator comes on for about 6 seconds and then goes off.
Was this page helpful?