Front Passenger's Weight Sensor Unit Operation Check
In this manual: Front Passenger's Weight Sensor Unit Operation Check
~1min read
Procedure
1. After Replacing Front Passenger's Seat Component(s) - Check
After Replacing Front Passenger's Seat Component(s)
NOTE: Check the front passenger's weight sensor unit operation after any of these actions:
- Front passenger's seat component(s) replacement or removal (except front passenger's weight sensor unit).
- Front passenger's weight sensor(s) replacement or removal.
- After a vehicle collision.
2. HDS - Connect
3. Front Passenger's Weight Sensor Unit - Operation Check
Front Passenger's Weight Sensor Unit Operation Check
- Make sure all the components of the front passenger's seat are correctly installed.
- Position the front passenger's seat all the way rearward, and adjust the seat-back to the forward most position. Do not move the seat from this position until the output check is completed.
- Make sure nothing is on the front passenger's seat, including aftermarket seat covers or mats.
- Make sure nothing is in the front passenger's seat-back pocket.
- Keep the windows and the moonroof closed (if equipped).
- Do all initialization procedures, except test-driving, in the service bay.
- Make sure the vehicle is on level ground.
- Dehumidify inside of the vehicle with A/C.
- Do not touch the front passenger's seat during the operation check.
- Do not expose the front passenger's seat to sudden temperature changes.
- Make sure all aftermarket devices (amplifiers, fluorescent light, air purifiers, CB or HAM radios, etc.) are turned off.
- Drive the vehicle, accelerate to 36 km/h, then stop on level ground.
Was this page helpful?