Front Individual Map Light Removal, Installation, and Test
In this manual: Front Individual Map Light Removal, Installation, and Test
7steps
~42min
2/5difficulty
Done 0 of 7
Removal/Installation
1. Front Individual Map Light - Remove
Front Individual Map Light: 5 W

- Turn the front individual map light switch OFF.
- Carefully pry off the lenses (A).
- Remove the front individual map light (B).
- Disconnect the connectors (C).
- Remove the bulb(s) (D).
2. All Removed Parts - Install
- Install the parts in the reverse order of removal.
Test
1. Front Individual Map Light - Test

NOTE: When doing the front individual map light test, make sure to install the bulbs correctly.
- Check for continuity between the terminals in each switch position according to the table.
- If the continuity is not as specified, replace the bulb(s) or the front individual map light (A).
Front Inner Fender Removal and Installation
Removal/Installation
1. Front Inner Fender - Remove
- Canada models: Remove the front splash guard (A).

2. All Removed Parts - Install
- Install the parts in the reverse order of removal.
Was this page helpful?