Transfer Output Shaft Transmission Housing Bearing Replacement
In this manual: Transfer Output Shaft Transmission Housing Bearing Replacement
2steps
~12min
1/5difficulty
Done 0 of 2
Replacement
1. Transmission Housing Bearing - Remove

- Remove the transmission housing bearing (A) by heating the transmission housing to about 212 ºF (100 ºC) using a heat gun (B).
NOTE: Do not heat the transmission housing more than 212 ºF (100 ºC).
2. Transmission Housing Bearing - Install

- Install the transmission housing bearing (A) in the direction shown.

- Drive the transmission housing bearing until it bottoms using the 66 mm oil seal driver.
Special Tool Required

- Oil Seal Driver, 66 mm 07947-3710200
Was this page helpful?